16
Unpacking
NOTE
The unpacking operation should be performed by an installation engineer.
To unpack the MaxiCharger (general procedure)
Check the tilt and inversion indicators and shock watch.
Observe the sensors attached to the wooden box for the degree of the tilt
and complete overturn. If the sensors demonstrate severe tilt (over 30°)
or total overturn as shown, refuse the delivery.
Figure 4-1 Tilt and Inversion Indicators
If the shock watch appears red, contact Autel customer service and the
delivery personnel, and then inspect the product for any damage. Do not
accept the delivery until the inspection is complete and no damage is
found.
Remove the packaging material and interior protection materials using
appropriate tools.
Inspect whether the MaxiCharger and the parts for installation are damaged. If
any damage is found or the parts are not consistent with the order, contact your
local dealer.
Make sure that all parts are delivered according to the order.
To Next Page
Loading...
