22
Installation
IMPORTANT
The installation should be performed by an installation engineer.
Make sure all required permits are granted form local authorities.
Make sure the AC input cable is available.
Make sure the tools for installation are prepared, see Table 4-2 Installation Tools.
Check the cable connection status and voltages before powering on the
MaxiCharger.
Make sure there is no voltage on the AC input cable during the entire installation
procedure.
To perform an installation (general procedure)
Prepare the site and unpack the MaxiCharger.
Install the cabinet.
Prepare for cable installation.
Connect the electrical wires.
Install the charging modules.
Install the external residual-current device.
Prepare for commissioning.
To Next Page
Loading...
