44 AutoFarm GPS AutoSteer
Wheel Angle Sensor Installation Guidelines
Figure 4-9 Wheel Angle Sensor Installation (example 4)
The Wheel Angle Sensor is shown in Figure 4-10 through Figure 4-12. Mount the linkage bracket to a moving part on the
steering axle such as a tie rod, or wheel knuckle. Mount the angle sensor bracket to a part that doesn’t move such as the axle.
When the wheels are turned, the linkage bracket should move relative to the angle sensor bracket. The linkage arm and rod
rotate the angle sensor when the wheels are turned. The standard linkage lengths are 12” but can be cut to a shorter length as
necessary.
Note: A coupling nut and jam nuts are provided to enable extending the threaded rods, if necessary.
Figure 4-10 Linkage Bracket Mounting (front view)
To Next Page
Loading...