System Settings
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 15
3.3 Restart System
Note that you always have to save a configuration (chapter 3.2) and
restart the system in order to activate a configuration:
each time a configuration has been changed
after an initial startup (part of the start-up procedure)
From the Service Menu, perform the following:
Press Enter to select System Settings.
Press the arrow down button to select Restart System, then press
Enter.
If the system is to be restarted after a configuration has been
changed, the following message will appear:
”System configuration data has been changed. If the system is
restarted without saving configuration data, the changes will be
lost. Save data before restarting?”
o Use the left arrow button to select Accept, then press Enter
twice.
o Type a new Site Name, or accept the existing one by pressing
the arrow down button.
o Type a new Operator Name, or accept the existing one by
pressing the arrow down button.
o Press Enter to type a new Site Configuration Version then
press Enter, or accept the existing one by pressing the arrow
down button.
o Press Enter to type a new Description then press Enter, or
accept the existing one by pressing the arrow down button.
o To confirm, press Enter.
After a short period the message “Configuration has been
saved” will appear.
o Press the left arrow button, then press Enter to confirm.
If the system is to be restarted after an intitial startup, the
following message will appear: “Restart of the system will perform
a controlled shutdown before restart. This may take a while,
depending on the system size.”
o Use the left arrow button to select Accept, then press Enter to
confirm.
The message ”System is now shutting down…” will appear,
and a bar will appear at the bottom showing the progress of the
reboot.
To Next Page
Loading...
