Unit Configuration
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 49
5.4.6 Disconnect from Output
This menu allows you to disconnect a selected point from an existing
output.
From the Points Menu (5.4.1), perform the following:
After pressing the Function button for the selected point(s), use
the arrow down button to scroll downwards to
Disconnect from Output, then press Enter.
In the display you will now see a list of all outputs that are connected
to the selected point .
To disconnect the selected point from an output, use the arrow
down button to select the output, then press Enter.
To confirm the setting, press Enter once more.
5.4.7 Disconnect from Activation Group
This menu allows you to disconnect a selected point from an existing
activation group.
From the Points Menu (5.4.1), perform the following:
After pressing the Function button for the selected point(s), use
the arrow down button to scroll downwards to
Disconnect from Activation Group, then press Enter.
A list of the activation groups the selected point is connected to will
appear in the display.
To disconnect the selected point from an activation group, use
the arrow down button to select the activation group, then press
Enter.
To confirm the setting, press Enter once more.
To Next Page
Loading...
Need help?
General
