Unit Configuration
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 47
5.4.4 Connect to Output
This menu allows you to connect a selected point to an output.
The following settings can be done:
Point State:
meaning which alarm level (pre-alarm or alarm) the point must
have before the output is activated.
Activate on Point Disable (Yes/No):
Yes: meaning that the output is activated if the selected point is
disabled.
No: meaning that the output is not activated if the selected point is
disabled.
Activate on Point Fault (Yes/No):
Yes: meaning that the output is activated if there is a fault on the
selected point.
No: meaning that the output is not activated if there is a fault on
the selected point.
From the Points Menu (5.4.1), perform the following:
After pressing the Function button for the selected point(s), use
the arrow down button to scroll downwards to
Connect to Output, then press Enter.
A list of all available outputs will appear in the display.
Use the arrow up/down button to select the output that
is to be connected to the selected point, then press Enter twice.
Use the left or right arrow button to set the Point State, then
press Enter.
Use the left or right arrow button to set Yes or No for Activate on
Point Disable, then press Enter.
Use the left or right arrow button to set Yes or No for Activate on
Point Fault, then press Enter.
To confirm the setting, press Enter once more.
To Next Page
Loading...
Need help?
General
