8410D User’s Guide
23 of 37
To adjust the
speakerphone to the
surrounding room
acoustics
Note: If you do not have a
Shift button, it is not
necessary to activate this
feature.
1
While on-hook, press Shift
• Red light next to
Shift goes on steadily
2
Press Speaker
• Red light next to
Shift goes off
• Red light next to
Speaker blinks
• You hear a series of tones as the speakerphone performs an acoustic
test of the environment. The display shows:
When the tones stop, your built-in speakerphone is ready for use.
Select Ring (and Ringer Volume)
To select a personalized
ringing pattern (for
those 8410 voice
terminals which have a
Shift button)
Note: For procedures on
selecting a personalized
ring for those 8410 voice
terminals that have a
Ring
button, see the next page.
1
Press Shift
• Red light goes on steadily
2
Press Hold
• Red light next to
Shift winks
• Current ringing pattern plays and repeats every three
seconds.
• If your 8410 has a display, it shows the ringing pattern you
are hearing, such as:
3
Continue to press (and then release) Hold (or, if you are
using a display set, you can also press Next or Prev ) to
cycle through all eight ringing patterns
4
When you hear the desired ringing pattern, press Shift again
• Your new ringing pattern is set
• If you have an 8410D, you hear confirmation tone
(two rising tones)
To Next Page
