Setting direct dial to rooms *
If direct inward dial to a room is disabled, an external caller cannot reach this guest directly
but must use the switchboard to connect.
1. Press the DDD (Disable Direct inward Dial) button.
The LEDs on the buttons of all rooms which cannot be called directly light up.
2. Press the button for the room you want to enable direct dial.
The button LED lights up which means that Direct Dial is enabled for the room.
If you want to disable Direct dial for a room, ensure that the LED for the
corresponding room is switched off.
3. Press the Exit button.
Setting guest-to-guest connection *
If a guest-to-guest connection is disabled, one guest cannot directly call another guest but
must use the switchboard to connect.
1. Press the Disable guest-to-guest button.
The LEDs for the buttons of all rooms that cannot directly call other room telephones
light up.
2. Press the button for the room you want to disable guest-to-guest dialing.
The LED for the corresponding button lights up or goes out, depending on the new
guest-to-guest connection status of the room.
3. Press the Exit button.
Determining the charge limit *
When you activate the charge limit for a room, the room guest can only incur charges up to
the specified limit. A signal tone indicates that the charge limit is reached. If the room guest is
on a call, the call continues uninterrupted but the system bars other external calls. The
Setting direct dial to rooms *
Avaya 9508 Series Digital Deskphone User Guide March 2011 115
To Next Page
Loading...
