Avaya G430 - Page 11

Equipment required for mounting on page 11
Equipment required for installing an S8300 Server on page 11
Equipment required if you are not installing an S8300 Server on page 11
Equipment required for installation
• One loop start analog trunk for connecting a modem
• A separate telephone line, if needed, for verbal communication during remote configuration
Related links
Required equipment on page 10
Equipment required for mounting
• A crosspoint screwdriver if rack mounting or wall mounting the Branch Gateway
• If you will mount the Branch Gateway on a flat wall: screws to fasten the Branch Gateway to
the wall
• If you will mount the Branch Gateway on a non-flat wall:
- A 48 in. x 48 in. (1.2 m x 1.2 m) plywood board (US: 3/4 inch plywood), 0.75 in. (20 mm)
thick.
- Wood screws to fasten the Branch Gateway to the plywood.
- Screws to fasten the plywood board to the wall (pan head at least ¾ in, #10-12 screw)
Related links
Required equipment on page 10
Equipment required for installing an S8300 Server
• One USB CD-ROM drive
• A laptop computer with Internet Explorer
Related links
Required equipment on page 10
Equipment required if you are not installing an S8300 Server
• A PC on the local network, optionally with a USB flash drive
• A laptop computer running Windows XP or Windows 2000 with an Ethernet port recognized by
the operating system on the laptop. If the port is recognized, it is listed by the Device Manager.
• A modem to connect to the Branch Gateway to enable dial-in configuration.
USB modems
supported by the Branch Gateway on page 130See USB modems supported by the Branch
Gateway on page 130 for a list of the USB modems supported by the Branch Gateway.
Related links
Required equipment on page 10
Before you install
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 11
Comments on this document? infodev@avaya.com