is no ability to notify the other party that they have been placed on hold. Pressing the Hold
button a second time causes the analog phone to remove the hold bridge and the call path is
restored. In essence, this hold operation is equivalent to using the Mute button on station
sets.
Flash button: A function that sends a switchhook signal to the server
Switchhook (receiver on/off hook): A function that sends a disconnect signal to the server
Using the Flash button
Procedure
1. Press the Flash button on the analog phone.
You hear a dial tone; the other party hears nothing.
You can leave the call on Hold or transfer the call. Press the Flash button twice to
return to the call.
2. Dial the Feature Access Code (FAC) for Hold.
At this point you can leave the call on Hold or transfer the call.
3. To return to the call, press the Flash button again.
The call is re-established.
Note:
Either party can put the call on Hold or return to the call.
Using the switchhook button
Procedure
1. Press the switchhook once.
You hear a dial tone.
2. Dial the FAC for Hold.
This places the call on Hard Hold which prevents you from transferring the call. To
return to the call, dial the FAC for Hold.
3. Do one of the following:
• Return to the call by dialing the FAC for Hold.
The call is re-established.
Standard Local Survivability (SLS)
112 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
