Avaya G430 - Dynamic Trap Manager

Command Description
set snmp
retries
Set the number of times to attempt to communicate with a particular
node
set snmp
timeout
Specify the time to wait for a response before retrying the
communication
show snmp Display SNMP configuration information, including a list of SNMP
notification receivers
show snmp
engineID
Display the SNMPv3 engine ID for the Branch Gateway
show snmp group Display a list of SNMPv3 groups
show snmp
retries
Display the number of retry attempts to make when attempting to
communicate with a node
show snmp
timeout
Display the time to wait before resending a communication
show snmp user Display configuration information for a specified SNMP user
show snmp
usertogroup
Display a table of SNMPv3 users and the groups to which they are
mapped
show snmp view Display configuration information for all SNMP views
snmp-server
community
Enable or disable SNMP access to the Branch Gateway
snmp-server
engineID
Specify the SNMP Engine ID for the Branch Gateway
snmp-server
group
Define a new SNMPv3 group, or configure settings for the group
snmp-server
remote-user
Configure settings for a remote SNMPv3 user. If the user does not
exist, it is created.
snmp-server
user
Configure settings for an SNMPv3 user. If the user does not exist,
it is created.
snmp-server
view
Configure settings for an SNMP MIB view. If the view does not exist,
it is created.
Dynamic trap manager
Dynamic trap manager is a special feature that ensures that the Branch Gateway sends traps
directly to the currently active MGC. If the MGC fails, dynamic trap manager ensures that traps
are sent to the backup MGC.
SNMP
Administering Avaya G430 Branch Gateway October 2013 313