Avaya G430 - Page 314

Note:
The dynamic trap manager is created by default and cannot be removed.
Related topics:
Dynamic trap manager parameters on page 314
Summary of dynamic trap manager configuration commands on page 314
Dynamic trap manager parameters
When you use the snmp-server dynamic-trap-manager command, you can configure
the following parameters:
• Whether to send traps or informs to the recipient
• The SNMP security model (v1 or v2c)
• The SNMP community name
• The UDP port of the target host to use as the destination UDP port when sending a
notification to this manager. Optional.
• The types of traps to be sent. Optional. The default is to send all types of traps. For a list
of possible notification types, see
Notification types on page 310.
Summary of dynamic trap manager configuration commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Command
Description
clear dynamic-
trap-manager
Remove administration of the dynamic trap manager
snmp-server
dynamic-trap-
manager
Specify the parameters of the dynamic trap manager feature
SNMP
314 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com