Avaya G430 - Firmware Version Control

To Next Page

To Previous Page

You can restore a backup copy of the configuration from the FTP or TFTP server or the USB

flash drive. When you restore the backup copy of the configuration, the backup copy becomes

the new running configuration on the Branch Gateway.

Related topics:

Saving configuration changes and backing them up on page 25

Saving configuration changes and backing them up

Procedure

1. To save changes to the configuration of the Branch Gateway, enter copy

running-config startup-config

A copy of the running configuration becomes the new startup configuration.

2. Back up either the running configuration or the startup configuration to an FTP,

TFTP or SCP server on your network, or to a USB flash drive.

For more information, see Configuration file backup and restore on page 98

Firmware version control

Firmware is the software that runs the Branch Gateway. The Branch Gateway has two firmware

banks:

• Bank A

• Bank B

Each firmware bank contains a version of the Branch Gateway firmware. These may be

different versions. The purpose of this feature is to provide redundancy of firmware. You can

save an old version of the firmware in case you need to use it later. This is particularly important

when uploading new versions.

Other manuals for Avaya G430