Policy list configuration
You can create and edit policy lists, and define the list identification attributes. You can also
delete an unnecessary policy list.
Related topics:
Creating or editing a policy list on page 561
Creating a list based on an existing list on page 562
Defining list identification attributes on page 562
Policy list attributes on page 563
Default actions on page 563
Deleting a policy list on page 563
Creating or editing a policy list
Procedure
To create or edit a list, do one of the following tasks:
• To create or edit a policy list, enter the context of the list.
If the list already exists, you can edit the list from the list context. If the list does
not exist, entering the list context creates the list.
• To create or edit an access control list, enter ip access-control-list
followed by a list number in the range 300-399. The Branch Gateway includes
one pre-configured access control list. The pre-configured access control list is
list number 300.
For example, to create access control list 301, enter the following command:
ip access-control-list 301
• To create or edit a QoS list, enter ip qos-list followed by a list number in the
range 400-499. The Branch Gateway includes one pre-configured QoS list. The
pre-configured QoS list is list number 400.
For example, to create a new QoS list 401, enter the following command:
ip qos-list 401
Policy lists
Administering Avaya G430 Branch Gateway October 2013 561
To Next Page
Loading...
