Command Description
show port flowcontrol Display port flow control information
Configuring the WAN Ethernet port
Procedure
1. Use the interface fastethernet 10/2 command to enter the context of the
port interface.
2. Perform basic configuration of the interface.
For more information, see
Interface configuration on page 422.
3. Use the Ethernet WAN port configuration commands in the context of the port
interface.
See
Summary of WAN Ethernet port configuration CLI commands on page 203.
Related topics:
Roadmap for configuring additional features on the WAN Ethernet port on page 202
WAN Ethernet port traffic shaping on page 202
About backup interfaces on page 203
Summary of WAN Ethernet port configuration CLI commands on page 203
Roadmap for configuring additional features on the WAN Ethernet port
• Primary Management Interface (PMI). For more information, see
Primary Management
Interface (PMI) configuration on page 64.
• Advanced router features. For more information, see
The router on page 479.
• VoIP queuing. For more information, see Commands used to configure QoS
parameters on page 240.
• Access control policy lists and QoS policy lists. For more information, see Policy lists on
page 557.
• SNMP Link Up and Link Down traps. For more information, see
SNMP trap
configuration on page 309.
WAN Ethernet port traffic shaping
You can use traffic shaping to determine the data transfer rate on the WAN Ethernet port. To
set traffic shaping, use the traffic-shape rate command in the interface context. To
Ethernet ports
202 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
