Command Description
set port speed Set the speed of a port or range of ports
show port auto-
negotiation-
flowcontrol-
advertisement
Display the flow control advertisement for a Gigabit
port used to perform auto-negotiation
show port edge state Display the edge state of a port
show port flowcontrol Display port flow control information
Command Description
set port duplex Configure the duplex type (full or half-duplex) of an
Ethernet or Fast Ethernet port or range of ports
set port edge admin
state
Determine whether the port is an edge port, for the
purposes of RSTP (Rapid Spanning Tree Protocol)
Edge port is a treatment assigned to ports for the
purposes of RSTP (Rapid Spanning Tree Protocol).
For more information about using this command and
RSTP configuration in general, see Rapid Spanning
Tree Protocol (RSTP).
set port enable |
disable
Enable or disable a port or a range of ports
set port flowcontrol Set the send/receive mode for flow control frames
(IEEE 802.3x or proprietary) for a full-duplex port
Each direction (send or receive) can be configured
separately. Use the show port flowcontrol command
to display port flow control information.
set port level Set the default packet priority level for untagged
packets
Packets traveling through a port set at normal priority
should be served only after packets traveling through
a port set at high priority are served.
set port name Configure a name for a port
set port negotiation Enable or disable auto-negotiation on the port
This command applies to the Fast Ethernet port.
When negotiation is enabled, the speed and duplex of
a Fast Ethernet port is determined by auto-
negotiation. If negotiation is disabled, the user can set
the speed and duplex of a Fast Ethernet port.
set port speed Set the speed of a port or range of ports
An error message is generated if you attempt to set
the speed when auto-negotiation is enabled.
show port edge state Display the edge state of a port
Switch Ethernet port configuration
Administering Avaya G430 Branch Gateway October 2013 201
To Next Page
Loading...
