Configuring contact closure hardware
Procedure
Connect an Avaya Partner Contact Closure Adjunct
™
to the Contact Closure port on
the Branch Gateway front panel, labeled CCA.
Use a telephone cable with standard RJ-11 connectors.
A qualified electrician should connect the electrical devices to the relays on the Avaya
Partner Contact Closure Adjunct
™
.
For information on contact closure specifications, see Overview for the Avaya Branch
Gateway G430.
Software contact closure
Contact closure modes
Mode Description
mgc The MGC controls contact closure. In mgc mode, the user dials
feature access codes to activate and deactivate contact closure.
manual-trigger Activates contact closure for the specified relay
manual-off Deactivates contact closure for the specified relay
Configuring contact closure software
About this task
To configure the Branch Gateway to activate contact closure when the feature access code is
dialed:
Procedure
1. Enter the set contact-closure admin command.
Contact closure
318 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
