Device status viewing
This section describes the commands used to view the status of the Branch Gateway. For
more information about these commands, see Avaya G430 Branch Gateway CLI Reference.
Related topics:
The show mm command on page 81
The show mm and show mg list config commands on page 81
Device status commands on page 82
The show mm command
Use the show mm command to view information about media modules that are installed on the
Branch Gateway. To view information about a specific media module, include the slot number
of the media module as an argument. For example, to view information about the media module
in slot 2, enter show mm v2. The output of the command shows the following information:
• Slot number
• Uptime
• Type of media module
• Description
• Serial number and other hardware identification numbers
• Firmware version
• Number of ports
• Fault messages
The show mm and show mg list config commands
Use the show module command or enter show mg list_config to view brief information
about media modules that are installed in the Branch Gateway. To view brief information about
a specific media module, include the slot number of the media module as an argument. For
example, to view information about the media module in slot 2, enter show module v2. The
output of the command shows the following information:
• Slot number
• Firmware version
Basic device configuration
Administering Avaya G430 Branch Gateway October 2013 81
To Next Page
Loading...
