Command Description
set port point-to-
point admin status
Specify a port’s connection type
set port spantree Enable or disable spanning tree for specific ports
set port spantree cost Set the spanning tree cost of a port
set port spantree
force-protocol-
migration
Force the port to send a rapid spanning tree hello
packet (Bridge Protocol Data Unit)
set port spantree
priority
Set the spanning tree priority level of a port
set spantree default-
path-cost
Set the version of the spanning tree default path cost
used by the current bridge
set spantree enable|
disable
Enable or disable the spanning-tree algorithm for the
Branch Gateway
set spantree forward-
delay
Specify the time used when transferring the state of a
port to the forwarding state
set spantree hello-
time
Specify the time interval between the generation of
configuration BPDUs by the root
set spantree max-age Specify the time to keep an information message before
it is discarded
set spantree priority Set the bridge priority for the spanning tree
set spantree tx-hold-
count
Set the value in packets used by the spanning tree in
order to limit the maximum number of BPDUs
transmitted during a hello-time period
set spantree version Set the version of the spanning tree protocol used by
the device
show port edge state Display the edge state of a specified port
show port point-to-
point status
Display the point-to-point status of a specific port or all
ports
show spantree Display spanning-tree information
Port classification
With the Branch Gateway, you can classify any port as either regular or valuable. Classifying
a port as valuable means that a link fault trap is sent in the event of a link failure. The trap is
Advanced switching
Administering Avaya G430 Branch Gateway October 2013 343
To Next Page
Loading...
