Configuring a session log
About this task
A session log is the display of system messages on the terminal screen. It is automatically
deleted when a session ends.
Procedure
1. Enter set logging session enable.
Gxxx-001(super)# set logging session enable
Done!
Note:
If the device is connected to several terminals, a separate session log is
established for each terminal.
2. Optionally, define filters to limit the types of messages received (see Logging filter
configuration on page 224).
Related topics:
Example discontinuation of the display of system messages on page 223
Example display of session logging configuration on page 223
Session logging message format on page 224
Example discontinuation of the display of system messages
The following output is an example of the set logging session disable command used
to discontinue the display of system messages to the terminal screen.
Example
Gxxx-001
(super)# set logging session disable
Done!
Example display of session logging configuration
The following output is an example of the show logging session condition. command
that displays whether session logging is enabled or disabled, and lists all filters defined for
session logging.
Example
Gxxx-001
(super)# show logging session condition
System logging
Administering Avaya G430 Branch Gateway October 2013 223
To Next Page
Loading...
