Related topics:
Commands used to activate session logging on page 271
Severity levels of the logging session on page 271
Commands used to activate session logging
To activate session logging for modem dial backup functions, type the following commands.
Logging messages will be sent to the terminal screen.
•
set logging session condition dialer information
•
set logging session condition usb-modem information
•
set logging session condition ppp information
Note:
Not all logging messages indicate problems. Some are generated to provide information on
normal working activity of the Dialer interface. For more information on logging configuration,
see
System logging on page 215.
Note:
Syslog and log file logging are also available. See System logging on page 215.
Severity levels of the logging session
The set logging commands must include a severity level. All logging messages with the
specified severity and higher are displayed. The following are the available severity levels:
Information: This message is for informational purposes and requires no action on your
part.
Debug: This message provides information that can be useful in debugging certain problems,
but requires no action itself.
Warning: This message indicates a condition requiring user intervention and
troubleshooting.
Modem dial backup logging messages
Dialer Messages
Dialer Messages are messages generated by the Dialer interface.
WAN interfaces
Administering Avaya G430 Branch Gateway October 2013 271
To Next Page
Loading...
