Chapter 3: Configuration overview
Configuration overview
A new Branch Gateway comes with default configuration settings. There are certain items that
you must configure, according to your system specifications, before using the Branch Gateway.
Configuration of other items depends on the specifications of your network.
A new Branch Gateway has two physical interfaces for management. These are the Services
interface and the USB-modem interface.
You must also ensure that the Branch Gateway is properly configured for whichever methods
you intend to use for accessing the Branch Gateway. For information on accessing the Branch
Gateway, see
Accessing the Branch Gateway on page 27.
Related topics:
About defining the Services interface on page 21
Defining the USB-modem interface on page 22
Other interfaces on page 22
Configuration using CLI on page 23
Configuration using GUI applications on page 23
Configuration changes and backups on page 24
Firmware version control on page 25
About defining the Services interface
No configuration of the Services interface is necessary. The Services interface has the fixed
IP address 192.11.13.6. However, the console device you connect to the Services port requires
a specific configuration of its network settings, as explained in Accessing the gateway through
the Services port on page 30.
Administering Avaya G430 Branch Gateway October 2013 21
To Next Page
Loading...
