Avaya G430 - Editing and Deleting PBR Lists

2. Use the next-hop-ip or next-hop-interface command again, without the
track keyword.
Changing the object tracker and keeping the next hop
Procedure
1. Enter the context of the next hop list.
2. Use the next-hop-ip or next-hop-interface command again, with the
track keyword followed by the new track index.
Editing and deleting PBR lists
About this task
You cannot delete or modify a PBR list when it is attached to an interface. In order to delete
or modify a PBR list, you must first remove the list from the interface. You can then delete or
modify the list. After modifying the list, you can reattach the list to the interface.
Procedure
1. To remove a list from an interface, use the no form of the ip pbr-group command
in the interface context.
The following example removes the PBR list from the VLAN 2 interface.
Gxxx-001(super)# interface vlan 1
Gxxx-001(super-if:VLAN 1)# no ip pbr-group
Done!
Gxxx-001(super-if:VLAN 1)#
2. To modify a PBR list, enter ip pbr-list, followed by the number of the list you
want to modify, to enter the list context.
Redefine the parameters of the list.
3. To delete a PBR list, enter exit to return to general context and enter no ip pbr-
list followed by the number of the list you want to delete.
Policy-based routing
596 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com