Avaya G430 - SNMP Configuration Examples

SNMP configuration examples
The following example enables link up/down traps on an Ethernet interface:
Gxxx-001(super)# interface fastethernet 10/3
Gxxx-001(super-if:FastEthernet 10/3)# snmp trap link-status
Done!
The following example displays SNMP information:
Gxxx-001(super)# show snmp
Authentication trap disabled
Community-Access Community-String
---------------- ----------------
read-only *****
read-write *****
SNMPv3 Notification Status
----------------------------
Traps: Enabled
Informs: Enabled Retries: 3 Timeout: 3 seconds
SNMP-Rec-Address Model Level Notification Trap/Inform User name
---------------- ----- ------ ------------ ----------- ----------
149.49.70.137 v1 noauth all trap ReadCommN
UDP port: 162 DM
The following example disables Link Up and Link Down traps on an Ethernet interface:
Gxxx-001(super-if:FastEthernet 10/3)# no snmp trap link-status
Done!
The following example creates a read-only user:
Gxxx-001# snmp-server user joseph ReadOnlyG v3 auth md5 katmandu priv des56
ktamatan
The following example creates a read-write user:
Gxxx-001# snmp-server user johnny ReadWriteG v3 auth md5 katmandu priv des56 ktamatan
The following example creates an admin user:
Gxxx-001# snmp-server user johnny v3AdminG v3 auth md5 katmandu priv des56 ktamatan
The following example sets the SNMPv1 read-only community:
Gxxx-001(super)# set snmp community read-only read
SNMP read-only community string set.
The following example sets the SNMPv1 read-write community:
Gxxx-001(super)# set snmp community read-write write
SNMP read-write community string set.
The following example enables link up/down trap on a LAN port on the G250:
G250-001(super)# set port trap 10/3 enable
Port 10/3 up/down trap enabled
SNMP
Administering Avaya G430 Branch Gateway October 2013 315