Root level command First level command Description
command regardless of which
compression method is employed.
show ip tcp
header-
compression
brief
Display a subset of TCP header
compression statistics in the form of a
table
Commands used to display and clear header compression statistics
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
•
show ip rtp header-compression
•
show ip tcp header-compression
• clear ip rtp header-compression .
•
clear ip tcp header-compression
Commands used to configure QoS parameters
The Branch Gateway uses MGCP (H.248) protocol for call signalling and call routing
information. Use the following commands to configure QoS for signalling and VoIP traffic.
• .set qos control
•
set qos signal
•
show qos-rtcp
•
set qos bearer
For more information about these commands, see
Summary of QoS, RSVP, and RTCP
configuration CLI commands on page 241.
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
VoIP QoS
240 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
