Avaya G430 - Page 82

• Type of media module
• Media module code
Device status commands
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Command Description
set utilization
cpu
Enable CPU utilization measurements
show faults Display information about currently active faults
show image
version
Display the software version of the image on both memory banks
of the device
show mg
list_config
Display the current hardware and firmware configurations for the
installed Branch Gateway equipment
show mgc Display information about the Media Gateway Controller with which
the Branch Gateway is registered
show module Display brief information about the media modules installed in the
Branch Gateway
show restart-
log
Display information about the last time the Branch Gateway was
reset
show system Display information about the Branch Gateway
show temp Display the device temperature
show timeout Display the amount of time in minutes the terminal remains idle
before timing out
show
utilization
Display information about CPU and memory usage on the Branch
Gateway
show voltages Display power supply voltages
Basic device configuration
82 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com