In the following example, the command sets contact closure to work in relay 1 of
the Avaya Partner Contact Closure Adjunct
™
when activated by the call
controller.
set contact-closure admin 10/1:1 mgc
2. Use the set contact-closure pulse-duration command to set the length
of time for the relay to return to normal after the call controller triggers it.
In the following example, the command sets relay 2 of the Avaya Partner Contact
Closure Adjunct
™
to return to normal five seconds after the call controller triggers
contact closure in the relay.
set contact-closure pulse-duration 10/1:2 5
Activating a contact closure manually
Procedure
Use the set contact-closure admin command with the parameter manual-
trigger.
In the following example, the command activates contact closure in relay 1 of the Avaya
Partner Contact Closure Adjunct
™
. Contact closure remains active until you deactivate
it by using the set contact-closure admin command with the parameter
manual-off or mgc.
set contact-closure admin 10/1:1 manual-trigger
Deactivating a contact closure manually
Procedure
Use the set contact-closure admin command with the parameter manual-off.
In the following example, the command deactivates contact closure in relay 2 of the
Avaya Partner Contact Closure Adjunct
™
. Contact closure will not operate, even
automatically, until you use the set contact-closure admin command to change
the status of contact closure to mgc or manual-trigger.
set contact-closure admin 10/1:2 manual-off
Showing contact closure status
Procedure
Use the show contact-closure command to display the status of one or more
contact closure relays.
Contact closure
Administering Avaya G430 Branch Gateway October 2013 319
To Next Page
Loading...
