disable traffic shaping, use the no form of the traffic-shape rate command. Traffic
shaping works in tandem with the configured bandwidth. If you change the traffic shape rate,
this automatically changes the bandwidth. Similarly, if you change the bandwidth, this
automatically changes the traffic shape rate.
Note:
The traffic shape rate is determined in bits. The bandwidth is determined in kilobytes.
For information on traffic shaping in general, see
Commands used to configure QoS
parameters on page 240.
About backup interfaces
You can configure backup relations between a pair of any Layer 2 interfaces, except the VLAN
interface. For instructions on how to configure backup interfaces, see Backup interfaces on
page 256.
Summary of WAN Ethernet port configuration CLI commands
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level command
Command Description
interface
fastethernet
Enter interface fastethernet configuration
mode
autoneg Set the port speed and duplex to auto-
negotiation mode
no autoneg Disable the auto-negotiation mode
duplex Set the duplex setting (full or half) for the
interface
keepalive-
track
Bind an object tracker to the interface to
check whether it is up
When activated, the object tracker sends
health check packets at defined intervals to
the other side of the interface. If the
configured number of consecutive keepalive
requests are not answered, the interface
track state changes to down. The object
tracker continues monitoring the interface,
and when its track state changes to up, the
interface state changes to up.
Switch Ethernet port configuration
Administering Avaya G430 Branch Gateway October 2013 203
To Next Page
Loading...
