Creating a list based on an existing list
Procedure
1. To create a new policy list based on an existing list, use the ip policy-list-
copy command followed by the name of the list from which you want to copy.
The source and destination lists must be of the same type. For example, you cannot
copy an access control list to a QoS list.
The following example creates a new access control list, number 340, based on
access control list 330. You can then enter the context of access control list 340 to
modify it.
Gxxx-001(super)# ip policy-list-copy 330 340
Done!
2. Once you have entered the list context, you can perform the following actions:
• Configure rules - see Policy rule configuration on page 568
• Configure composite operations - see Composite operations on page 574
• Configure DSCP mapping (QoS lists only) - see DSCP table on page 577
Defining list identification attributes
About this task
The policy list attributes including name, owner, and cookie, are used by Avaya QoS Manager
software to identify policy lists.
Procedure
1. Enter the context of the policy list in which you want to define the attribute.
2. Enter one of the following commands, followed by a text string or integer:
•
name
•
owner
•
cookie
3. To set a policy list attribute to its default setting, use the no form of the appropriate
command.
For example, to set a list to its default name, use the command no name.
4. To view the attributes, use the show list command in the context of the list.
Policy lists
562 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
