Avaya G430 - Page 312

Root level command Command Description
set port trap Enable or disable SNMP Link Up and
Link Down traps notifications and traps
on a port
set snmp trap
enable |
disable auth
Enable or disable authentication failure
traps for all managers
set snmp trap
enable |
disable frame-
relay
Enable or disable frame relay traps for
all managers
show port trap Display information on SNMP generic
Link Up and Link Down traps sent for a
specific port or for all ports
show snmp Display SNMP configuration information
snmp-server
enable
notifications
Enable or disable the sending of all traps
and notifications from the Branch
Gateway
snmp-server
host
Identify an SNMP management server,
and specify the kind of messages it
receives. Use the no form of the
command to remove the specified
server, or to disable a particular set of
notification types.
snmp-server
informs
Configure the SNMPv3 timeout and
retries for notifications
Summary of SNMP access configuration commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Command
Description
ip snmp Enable or disable the SNMP agent for the Branch Gateway
set snmp
community
Create or modify an SNMPv1 community
SNMP
312 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com