Avaya G430 - Page 174

Country code Description Possible
Values
Country 13
(Germany)
German National PRI
ETSI
invalid
invalid
a
b
c
d
ETSI Full message set, including RESTART
No RESTART message
invalid
invalid
a
b
c
d
Administering BRI parameters
Procedure
1. Enter bri slot-address, where slot-address is any permitted port.
The command line prompt changes to sls-bri <slot-address>. If you want to remove
the BRI link from the SLS administration, enter exit to leave the second-level bri
context and return to the (super-sls)# context, and then enter clear bri slot-
address.
2. Enter set name name to identify the user name for the DS1 trunk.
Use the 1-27 character name, as specified on Communication Manager (add
trunk-group n). Type the name string inside double quotes.
3. Enter set interface glare-mode to specify the glare-handling convention.
glare-mode can be one of the following values:
For non-QSIG calls: For QSIG calls:
• network. If the Branch Gateway is
connected to a host computer and
encounters glare, it overrides the
far-end
• user. If the Branch Gateway is
connected to a public network and
encounters glare, it releases the
circuit
• peerMaster. SLS overrides the other
end when glare occurs
• peerSlave. SLS releases the circuit
when glare occurs
4. If the BRI link is employed with ISDN, and the glare-handling convention is specified
as peerMaster or peerSlave for the ISDN link (set in Step 3), enter set side
side to specify the glare mode: either a or b.
Standard Local Survivability (SLS)
174 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com