Avaya G430 - Page 243

Summary of WFVQ configuration CLI commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level
command
Command Description
interface
(fastethernet|
dialer)
Enter the FastEthernet, or Dialer interface
configuration context
fair-queue-
limit
Specify the maximum number of packets
that can be queued in the weighted fair
queue. The upper and lower limits of this
command depend on the amount of
bandwidth configured for the interface.
Use this command only for troubleshooting.
fair-voip-
queue
Enable Weighted Fair VoIP Queuing
(WFVQ) on the current interface. WFVQ is
the recommended queuing mode for
interfaces.
The no form of the fair-voip-queue
command does not exist. If you enter the
command no fair-voip-queue, it will
actually enable WFVQ if WFVQ is not
already enabled.
priority-queue Enable or disable priority queuing mode in a
FastEthernet interface. If you disable priority
queuing, WFVQ is re-enabled.
show queue Display information about the real-time
status of output queues for the current
interface
voip-queue Enable or disable custom queueing for VoIP
traffic. If you disable custom queueing,
WFVQ is re-enabled.
show queueing Display the WFVG configuration
VoIP QoS
Administering Avaya G430 Branch Gateway October 2013 243