Avaya G430 - Page 249

Root level
command
Command Description
async reset-
modem
Reset the connected modem. You can use this
command from within an active PPP session
over the USB modem
ip address Assign an IP address and mask to an interface.
This is the IP address to which a remote user
can connect using SSH/Telnet.
ip peer
address
Change the IP address offered to a requesting
calling host during PPP/IPCP connection
establishment. By default, the interface offers its
own IP address plus one.
ppp
authenticatio
n
Configure the authentication method used when
starting a client session on the PPP server.
See The ppp authentication command
parameters on page 248.
ppp chap-
secret
Configure the shared secret used in PPP
sessions with CHAP authentication
ppp timeout
authenticatio
n
Set the maximum time to wait for an
authentication response
show ppp
authenticatio
n
Display PPP authentication status
shutdown Disconnect an active PPP session and shut
down the modem
timeout
absolute
Set the number of minutes until the system
automatically disconnects an idle PPP incoming
session. By default, the timeout value is 10
minutes.
show
interfaces
Display interface configuration and statistics for
a particular interface or all interfaces
show
interfaces
usb-modem Display the USB-modem interface parameters,
the current status of the USB port, and the
identity of any USB modem connected to the
USB port.
Modems and the Branch Gateway
Administering Avaya G430 Branch Gateway October 2013 249