For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level command Command Description
interface
fastethernet
Enter the FastEthernet interface context
encapsulation
pppoe
Change the encapsulation to PPPoE
ip address Configure an IP address and subnet
mask for the interface
ip address
negotiated
Obtain an IP address via PPP/IPCP
negotiation
keepalive Enable PPP keepalive, in order to
maintain a persistent connection
keepalive-track Bind interface status to an object tracker
to check whether the interface is up
mtu Set the interface’s MTU to 1492, which
ensures that overall packet size for the
PPPoE interface does not exceed 1500,
which is the MTU for Ethernet
ppp chap hostname Override the device hostname for PPP
CHAP authentication
ppp chap password Set the CHAP password for
authentication with a remote peer
ppp chap refuse Prevent the device from authenticating
with CHAP after the device is requested
by the remote peer
ppp ipcp dns
request
Enable or disable requesting the list of
available DNS servers from the remote
peer during the PPP/IPCP session
ppp pap refuse Prevent the device from authenticating
with PAP after the device is requested
by the remote peer
ppp pap-sent
username
Set the Password Authentication
Protocol (PAP) password for
authentication with the remote peer
ppp timeout ncp Set the maximum time, in seconds, that
PPP allows for negotiation of a network
layer protocol
ppp timeout retry Set the maximum time to wait for a
response during PPP negotiation
WAN interfaces
254 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
