Avaya G430 - Page 275

Log Message Severity Possible cause Action
request is sent, and goes down
when the link is terminated.
PAP passed/
failed
Debug This message is sent when the
authenticating station responds
to the PAP authentication
request.
None required.
CHAP passed/
failed
Debug This message is sent when the
authenticating station responds
to the CHAP authentication
request.
None required.
IPCP Up/Down Debug PPP uses IPCP to define the IP
characteristics of the session. IP
packets cannot be exchanged
until IPCP is in the Up state.
None required.
IPCP IP reject Warning This message is generated
when IPCP attempts to define
the IP characteristics for a PPP
session, but does not have the
IP address of the local interface
to define the session. Without IP
address information on both
sides of the session, the PPP
session cannot begin passing IP
traffic.
Troubleshooting steps:
• Check Dialer
interface
configuration to
ensure an IP address
is configured, either
as a static address or
through Dynamic IP
addressing or
through IP
unnumbered.
Summary of modem dial backup commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level
command
Command Description
interface
dialer
Enter the Dialer interface configuration
context
dialer modem-
interface
Associate a Dialer with a modem interface
WAN interfaces
Administering Avaya G430 Branch Gateway October 2013 275