Enter set port point-to-point admin status, followed by the module and port
number or a range of port numbers, and an admin status parameter, to specify the port’s
connection type. Admin status parameter values are:
• force-true. Treats the port as if it is connected point-to-point
• force-false. Treats the port as if it is connected to shared media
• auto. Attempts to automatically detect the port’s connection type
For example, the following command specifies that ports 10/5 and 10/6 are treated as if they
were connected point-to-point:
Gxxx-001(super)# set port point-to-point admin status 10/5-6 force-true
All ports: Enter show port point-to-point status, followed by the module and port
number, to display the point-to-point status of the specified point-to-point status of all ports
Spanning tree configuration examples
The following example enables spanning tree on a port:
Gxxx-001(super)# set port spantree enable 10/5
port 10/5 was enabled on spantree
The following example disables spanning tree on a port:
Gxxx-001(super)# set port spantree disable 10/5
port 10/5 was disabled on spantree
The following example sets the spanning tree cost of port 10/5 to 4096:
Gxxx-001(super)# set port spantree cost 10/5 4096
port 10/5 spantree cost is 4096
The following example configures the version of the spanning tree default path cost used by
this bridge:
Gxxx-001(super)# set spantree default-path-cost common-spanning-tree
Spanning tree default path costs is set to common spanning tree.
The following example configures the time used when transferring the port to the forwarding
state:
Gxxx-001(super)# set spantree forward-delay 16
bridge forward delay is set to 16.
The following example configures the time interval between the generation of configuration
BPDUs by the root:
Gxxx-001(super)# set spantree hello-time 2
bridge hello time is set to 2.
Advanced switching
Administering Avaya G430 Branch Gateway October 2013 341
To Next Page
Loading...
