Avaya G430 - Page 372

A traceroute is performed per RTP session, 10 seconds after the session begins. A traceroute
is not performed if there is another active session to the same destination for which a traceroute
was already performed within the last five seconds.
Procedure
Use the show rtp-stat traceroute command.
You can filter the results according to subnet address by adding destination-ip
and specifying the remote subnet address and subnet mask, or by specifying the rtp-
statistics session index.
For example:
Gxxx-001(super)# show rtp-stat traceroute destination-ip 10.2.5.0
255.255.255.0
Session ID: 1234
From: 123.21.11.5, To: 10.2.4.15, At: 2004-12-26,12:21:55
TTL HOP ADDRESS DELAY
--- --------------- --------
1 123.21.11.1 2ms
2 212.201.233.102 65ms
3 213.21.51.12 110ms
4 10.2.4.15 175ms
Session ID: 1234
From: 123.21.11.5, To: 10.2.4.5, At: 2004-12-26,13:30:15
Result
Note:
The traceroute results are displayed with the most recent first.
RTP traceroute results output
Name
Description
Session ID The RTP statistics index for the RTP session
From The IP address of the Branch Gateway
To The IP address of the session destination (in
this case, a destination within the specified
subnet)
At The time the traceroute is performed
TTL The hop count and TTL field value of probe
packets
HOP ADDRESS The hop IP address
DELAY The round trip time per probe packet. Three
probe packets are sent per hop address, and
the displayed value is the average of the
Monitoring applications
372 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com