Uploading the capture file to a remote server or USB mass storage device
Procedure
Use one of the following commands to upload the capture file:
•
copy capture-file ftp
•
copy capture-file tftp
•
copy capture-file scp
•
coyy capture-file usb
Result
Note:
The use of the copy capture-file scp command is limited to uploading files of 1 MB
or less.
For example:
Gxxx-001(super)# copy capture-file ftp myCature.cap 135.64.103.66
This command will stop the capture if capturing is started
Confirmation - do you want to continue (Y/N)? y
Username: xxxx
Password: xxxx
Beginning upload operation ...
This operation may take up to 20 seconds.
Please refrain from any other operation during this time.
For more information , use 'show upload status 10' command
Gxxx-001(super)#
Uploading the capture file to an S8300 Server
Procedure
1. Telnet into the S8300 Server, for example by entering session mgc.
2. Open the Avaya Maintenance Web Interface.
For instructions on accessing the Avaya Maintenance Web Interface, see Installing
and Upgrading the Avaya Branch Gateway G430.
3. In the Avaya Maintenance Web Interface, select FTP under Security in the main
menu.
4. Click Start Server .
5. Log into the Branch Gateway.
6. Use the copy capture file ftp command to upload the capture file.
Specify that the capture file should be placed in the ftp /pub subdirectory.
For example:
Gxxx-001(super)# copy capture-file ftp pub/capfile.cap 149.49.43.96
Monitoring applications
398 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
