Avaya G430 - Page 409

Address 149.49.75.178, bind to PMI, ID 00:04:0d:6d:30:48
Scheduler list:
3: 135.64.102.76:50002
Ports: Control 8889, RTP-test 8888, RTP-echo 8887
Test rate limiter: Maximum 60 tests in 10 seconds
Last Test: none
Test Count Failed Cancelled
---------- ------ ------ ---------
traceroute 0 0 0
rtp 0 0 0
ping 0 0 0
tcpconnect 0 0 0
merge 0 0 0
//to enable the test plug service:
Gxxx-001(super)# cna testplug-service
Done!
//to display test plug configuration and counters after some running time:
Gxxx-001(super)# show cna testplug
CNA testplug 1 is up, test-plug status is running a test
Address 149.49.75.178, bind to PMI, ID 00:04:0d:6d:30:48
Scheduler list:
3: 135.64.102.76:50002
Ports: Control 8889, RTP-test 8888, RTP-echo 8887
Test rate limiter: Maximum 60 tests in 10 seconds
Last Test: traceroute to 135.64.103.107
Result:
ip1=149.49.75.178 ip2=135.64.103.107 ttl_len = 4
Test Count Failed Cancelled
---------- ------ ------ ---------
traceroute 4 0 0
rtp 3 0 0
ping 2 0 0
tcpconnect 4 0 0
merge 0 0 0
Resetting the CNA test plug counters
Procedure
In the CNA testplug context, enter clear counters.
Gxxx-001(cna-testplug 1)# clear counters
All CNA test plug counters are cleared.
Summary of CNA test plug commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
Monitoring applications
Administering Avaya G430 Branch Gateway October 2013 409