Avaya G430 - Page 428

vlan interface 1, configured above:
Gxxx-001(super-if:Dialer 1)# ip unnumbered 1 Vlan 1
Gxxx-001(super-if:Dialer 1)# exit
Gxxx-001(super)# !
The following sample routing table shows how routes discovered on unnumbered interfaces
by routing protocols are listed as via routes in the Next-Hop column:
Network Mask Interface Next-Hop Cost TTL Source
----------- ----- ------------- --------------- -------- ----- ---------
0.0.0.0 0 FastEth10/3 149.49.54.1 1 n/a STAT-HI
2.2.2.0 24 Vlan15 2.2.2.1 1 n/a LOCAL
10.0.0.0 8 Vlan1 0.0.0.40 1 n/a LOCAL
3.0.0.0 8 Tunnel1 Via Dia.1 2 172 RIP
4.0.0.0 8 Tunnel 1 Via Dia.1 2 172 RIP
20.0.0.0 8 Tunnel 1 Via Dia.1 11112 n/a OSPF
20.0.0.1 32 Tunnel 1 Via Dia.1 22222 n/a OSPF
26.0.0.0 8 Vlan 15 2.2.2.2 3 n/a STAT-LO
99.0.0.0 8 Vlan 99 99.1.1.1 1 n/a LOCAL
135.64.0.0 16 FastEth 10/3 149.49.54.1 1 n/a STAT-HI
149.49.54.0 24 FastEth 10/3 149.49.54.112 1 n/a LOCAL
180.0.0.0 8 Loopback 1 180.0.0.1 1 n/a LOCAL
Summary of unnumbered IP interface configuration commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level
command
Command Description
interface
(dialer|
fastethernet|
serial|
tunnel)
interface
(dialer|
Enter the Dialer, FastEthernet,
Serial, or Tunnel interface context
Enter the Dialer, FastEthernet, or
Tunnel interface context
The router
428 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com