Avaya G430 - Page 460

For example, to add a static ARP table entry for station 192.168.7.8 with MAC address
00:40:0d:8c:2a:01, use the following command:
Gxxx-001# arp 192.168.7.8 00:40:0d:8c:2a:01
Changing an entry in the ARP table
Procedure
To change an entry in the ARP table, delete the entry and reinsert it with revised
parameters.
Summary of ARP table commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Command
Description
arp Add a permanent entry to the ARP table
no arp Remove either a static entry or a dynamically-learned entry from the
ARP table
arp timeout Configure the amount of time, in seconds, that an entry remains in
the ARP table
Entering this command without a time parameter displays the current
timeout value.
no arp timeout Restore the default value (four hours)
clear arp-
cache
Delete all dynamic entries from the ARP table and the IP route cache
ip max-arp-
entries
Specify the maximum number of ARP table entries allowed in the
ARP table
no ip max-arp-
entrie
Restore the maximum number of ARP table entries allowed in the
ARP table to default value
show ip arp Display a list of the ARP resolved MAC to IP addresses in the ARP
table
The router
460 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com