Root level
command
First level
command
Second level
command
Description
next-hop-ip Add the specified ip address to
the next hop path for this next-hop
list
show next-
hop
Display the next-hop entries in the
current list
interface Enter the interface configuration
mode for a Dialer, Loopback, Fast
Ethernet, Tunnel or VLAN
interface
ip pbr-
group
Apply the specified PBR list to the
current interface. The PBR list is
applied to ingress packets only.
ip pbr-list Enter the context of the specified
PBR list. If the list does not exist,
it is created.
cookie Set the cookie for the current list
ip-rule Enter configuration mode for the
specified rule. If the specified rule
does not exist, the system creates
it and enters its configuration
mode.
destination-
ip
Specify the destination IP
address of packets to which the
current rule applies
dscp Specify the DSCP value that is set
by the current policy operation
fragment Apply the current rule for non-
initial fragments only
icmp Apply the current rule to a specific
type of ICMP packet
ip-protocol Apply the current rule to packets
with the specified IP protocol
next-hop Specify the next-hop policy to use
when the current rule is applied
show ip
next-hop-
list
Display the details of the next-hop
list or of all next-hop lists
show ip-rule Display the attributes of a specific
rule or all rules
Policy-based routing
602 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
