Figure 68: Configuring general camera settings from the web interface
2. Configure the camera connection as described in Table 21: Configuring general camera
settings on page 101:
Table 21: Configuring general camera settings
Field Name Description
Default camera Select the port of the XT Codec Unit which you connected the default camera, which is
automatically activated when the system powers up. To configure your default camera
for the XT5000 Series, you can choose between HD1, [HD2, HD3, HD4 using the
Scopia
®
XT Camera Switch], DVI, or USB. To configure the default camera for the
XT7000 Series, you can choose between HD1, HD2, [HD3, HD4, HD5 using the
Scopia
®
XT Camera Switch], DVI, or USB.
Figure 69: Video inputs of the XT Codec Unit (XT5000 Series)
Figure 70: Video inputs of the XT Codec Unit (XT7000 Series)
• HD1( or HD1/HD2 in the case of the XT7000 Series): Select if you connected the
PTZ camera to the HDMI input of the XT Codec Unit. This is the most common
configuration.
Table continues…
Configuring Cameras
April 2015 Avaya Scopia
®
XT Series Deployment Guide 101
Comments? infodev@avaya.com
To Next Page
Loading...
