Avaya Scopia XT Executive - Page 129

Figure 88: Configuring general call settings
2. Set the fields as described in the following table.
<auto > is the default setting. It indicates that the system tries to choose the settings that
best suit the local situation.
Table 36: Configuring bandwidth settings of a call
Field Name Description
IP > Rate (K) Sets the maximum bitrate used for a single point-to-point call.
Audio Coding Sets the preferred audio codec that the system tries to send. The
remote system must support the same codec for a successful
connection.
Video Coding Sets the preferred video codec that the system tries to send, if the
remote system supports the same codec.
DualVideoCoding Sets the resolution for H.264 content video.
Use manual DualVideo
bandwidth
If set to Yes allows to change bandwidth used for content and live
video (DualVideo/Live bandwidth).
DualVideo/Live bandwidth Sets more bandwidth on Live Video or Content.
ISDN > Rate (K) Sets the maximum call rate that the system uses for any ISDN call.
Local audio-video If using the system as an endpoint which also hosts meetings on its
built-in MCU, select Yes to include local video and audio in
videoconferences.
Table continues…
Setting Call Bandwidth in XT Series
April 2015 Avaya Scopia
®
XT Series Deployment Guide 129
Comments? infodev@avaya.com