Figure 26: Connecting cables to the back of the camera
4. With the camera turned off, set the System Select switch on back of the camera to 7 using a
slotted 2.5 mm screwdriver (
Figure 26: Connecting cables to the back of the camera on
page 50).
5. Insert the two connectors on the other end of the camera cable to the ports on the XT Codec
Unit (Figure 27: Connecting the camera cables to the XT Codec Unit on page 51).
For the XT7000 Series, use the ports located under on the XT Codec Unit.
• Connect the HDMI plug to the vertical socket.
• Connect the other plug (power) to the horizontal socket.
We recommend keeping the DVI socket available for a computer connection (for example, to
share content in a videoconference).
Setting Up the XT Series Hardware
50 Avaya Scopia
®
XT Series Deployment Guide April 2015
Comments? infodev@avaya.com
To Next Page
Loading...
