Avaya XT Series - Page 31

3. If you are registering your endpoint to a SIP server, select Next and continue with
Configuring Basic SIP Settings on page 31. Otherwise, select Done to complete the
Quick Setup Wizard.
For Avaya XTE240 only, to configure using your keyboard and mouse to navigate the
menus, continue with
Installing Avaya Room System XT Control to Use Keyboard and
Mouse (Avaya XTE240) on page 32.
Related links
Configuring Basic Settings with the Quick Setup Wizard on page 27
Configuring Basic SIP Settings
About this task
This section explains how to register your Avaya XT Series to the SIP server.
The Avaya XT Series can function in a SIP environment, where endpoint names or numbers are
managed by SIP servers, not gatekeepers. You can dial an endpoint by entering its name or
number like 1234 or joe_smith, rather than remembering its IP address, where the SIP server
routes the call correctly. To do this, the SIP server must register all endpoints to maintain the
mapping list of names/numbers and endpoints to successfully route calls.
Before you begin
Access the quick setup wizard from the endpoint or web interface, as described in
Configuring
Basic Settings with the Quick Setup Wizard on page 27, and skip to this step.
Verify that you have the following information about your SIP environment:
• The DNS name or IP address of the SIP server. You can define up to three servers.
• For the SIP infrastructure that requires a SIP user authentication, credentials for
authenticating Avaya XT Series to the SIP server.
Procedure
1. Enter information for the SIP server, as described below.
In redundant SIP deployments, the Avaya XT Series uses this server as the default SIP
server.
Table 3: Configuring basic SIP settings for the Avaya XT Series
Field Description
User Enter the system name (or number). The system is registered to
the SIP server under this name.
When connecting over SIP, this name is displayed on the monitors
participating in the videoconference (for example, John-Smith, or
9th-Floor-Room) .
Authentication Name If necessary, enter the name for authenticating the Avaya XT
Series with the SIP server. It can be the same as the User
parameter.
Table continues…
Using the Setup Wizard to Easily Start your Avaya XT Series
March 2021 User Guide for Avaya XT Series 31
Comments on this document? infodev@avaya.com