2-6 System Administrator’s Guide Classification: Avery Dennison - Public
Cut Modes with RFID
Using RFID supplies, we recommend cut modes 1, 2, and 4 because
♦ cut modes 3, 5 and 6 may cause ribbon tearing.
♦ RFID supplies are more prone to curl and may cause a jam.
Contact Technical Support to order replacement 300 dpi printheads (KST) for use with the
cutter and RFID supplies.
Setting the Backfeed
Backfeed advances each printed label to the desired dispense position. Once that label is
removed, the next label to be printed is backed up underneath the printhead.
Select To
Off Disable backfeed.
On Enable backfeed. The printer moves the supply backwards before
printing. Use the Positioning menu to set the dispense position and the
backfeed distance.
Adjusting the Position Settings
This menu includes selections to change the print, supply, margin, cut, dispense, and
backfeed distance positions.
See the following graphic for a representation of the following adjustments: dispense
position, backfeed distance, supply position, print position, and margin position.
To Next Page
Loading...
