Avery Dennison ADTP1 - Selecting the Inlay; Entering the Inlay Position

8-4 System Administrator’s Guide Classification: Avery Dennison - Public
Selecting the Inlay
This option only appears in the Easy Setup menu. You must know the name of the RFID
inlay being used. Names and pictures of the approved inlays are in the RFID Printer
Setup Utility. Load RFID supply before you enter values in the Easy Setup menu.
The printer contains a list of approved inlays. If your RFID inlay is not listed, it may not
be qualified for use or update the printer’s
RFID inlay database (d46ESxx.db). See
“Updating the RFID Inlay Database
” for more
information. The RFID Printer Setup Utility
has database updates and downloads.
1. The inlay’s name may be on the supply
core’s label; otherwise, look at pictures of
the approved inlays in the RFID Printer Setup Utility. For example, AD-383U7 GNC.
2. Press  or  to select your inlay, then press SET. “Custom” appears as the
selected inlay’s name if the print speed is increased or any RFID settings are
changed.
Entering the Inlay Position
This option only appears in the Easy Setup menu. The inlay position must be entered in
millimeters. Measure the inlay position as shown to the nearest whole millimeter. For
example, if the measured distance is 7.25mm, enter 7mm.
1. The inlay’s position (in millimeters) may
be on the supply core’s label. For example,
enter 002 as 2.
2. Enter the inlay’s position, then press SET.
Select
To

Decrease the inlay distance.
 Increase the inlay distance.
Press 1 to toggle the amount (1, 10, or 100).
The printer may prompt to calibrate when exiting the
Easy Setup menu. Press START to calibrate or STOP to cancel.
The calibration prompt appears when the inlay type or the inlay distance changes.
Measure this
distance