Classification: Avery Dennison – Public Setting Defaults 6-7
Setting the Batch Packet Mode (Ignore BchCtl)
The printer can respond to or ignore all batch control fields within batch packets. This
option is available in firmware version 3.2 or greater. Refer to the Packet Reference
Manual for more information about the batch control field.
Some third-party label design packages include batch control fields within a batch packet.
The batch control field sets the following:
♦ feed mode ♦ batch separators
♦ cut mode ♦ print multiple
♦ verifier mode ♦ multiple part tags
♦ image rotation
The batch control field overrides settings made at the printer and in online configuration
packets.
We recommend changing your host’s data stream, but if that is not possible, enable this
option. Use caution if ignoring the batch control field, because the printer may not
operate as expected.
Select To
Disable The printer responds to all batch control fields within a batch packet.
Enable The printer ignores all batch control fields within a batch packet.
This is useful when you cannot change your host’s data or when you
want the printer to operate as specified through the printer’s menu.
Setting the Error Retry Mode
The printer either reprints the job or discards/cancels the job after a supply error is
cleared. Depending on your environment, you may not want jobs reprinted.
Select To
Disable
The printer discards the job that was in process and does not reprint it.
Enable
The printer reprints the job that was in process when the error
occurred.
To Next Page
Loading...
