Classification: Avery Dennison – Public Setting RFID Options 8-9
Enabling Tag Saver
This option only appears in the Advanced Setup menu. Not all RFID supplies support tag
saver. The default is no.
Select To
Yes Enable tag saver. The printer moves the first tag in the batch
backwards to the proper position before encoding.
Note: Some supplies are sensitive to backfeeding and may cause
jams.
No Disable tag saver. The printer does not move the first tag in the batch
backwards before encoding.
If tag saver is disabled and an error occurs during external verification,
the tag with an error does not have an overstrike pattern.
Setting the First TID Position
This option only appears in the Advanced Setup menu. The first TID position is only used
in non-stop encode mode with singulate mode enabled. The range is 0 to 2000. The
default is 0. The first TID position moves the ‘hotspot’ of the first inlay over the antenna
so the TID order can be calculated. This process is only used on the first inlay, trailing
inlays use the start encode position for setup. The ‘hotspot’ is the antenna’s most
sensitive programming area, which varies for each type of inlay.
The first TID position should “trail” after the start encode position; otherwise, error 737
occurs.
Use the RFID Printer Setup Utility to determine the first TID position then enter the value
at the printer.
Select To
Decrease the setting.
Increase the setting.
Press 1 to toggle the amount (1, 10, or 100).
First TID Position
Trailing Edge
0,0 point
Leading Edge
To Next Page
Loading...
